lopy

EDIT [2018-06-05]: I have updated the code with the Firmware 1.18.+ releases. The code is available at our Growing Data Foundation Github. These notes are to assist Australian IoT enthusiasts to get started in connecting a LoPy to The Things Network as it is unfortunately (not yet) straight forward to make them work with the current AU-915 TTN Channel plans. As the initiator of the local Adelaide Community of The Things Network I have been experimenting with a number of devices to connect sensors to #TTNADL. One of my personal favourites is the Pycom LoPy as a nice middle-ground between capabilities and technical complexity. However I ran into a problem where the LoPy would not get a signal back from the TTN network when joining over OTAA even though the TTN Console (http://console.thethingsnetwork.org/) the device showed as connected. With some friendly help from Jose Marcelino at the Pycom Forum this turned out to be an issue with the 915MHz frequency regions. Since there is no actual a standard governing which of the channels are used by TTN gateways, what is outlined here is what is implemented by most TTN communities down under (I know that at least ADL, BNE, SYD and WOL adhere to those). This is the typical Sub-band 2 (Channel 8-15) implementation of AU ISM 915 with TTN Gateways. This channel plan is also implemented by the install script for the MultiTech Conduit Gateways which are currently the most common gateways installed across Australia (see https://github.com/TheThingsNetwork/gateway-conf/blob/master/AU-global_conf.json) Channel#DirectionFrequency MHzBandwidth…